Unduhan Firmware dan Driver Seri Epilog Fusion Pro

Epilog Software Suite 2.1.10 (1/6/2020)

• Semua yang Anda butuhkan untuk menjalankan sistem Fusion Pro Anda
• Installs the Epilog Job Manager and the Epilog Laser Dashboard

Versi 2.1.10 Catatan Rilis

• Bug fixes and improvements

- For more information on the Job Manager, click here.
- Download Software Suite install and use instructions.

- For information on how to use the new Construction Lines feature, click here.

Harap diingat: Remove previous version of Epilog Job Manager and Epilog Software Suite before installation! (Go to Control Panel > Programs and Features and remove the software.)

Harap diingat: Windows 7/8/10 diperlukan untuk menggunakan Pengelola Pekerjaan Epilog.

Firmware: 1.0.2.2 (12/31/2019)

Harap diingat: Be sure to update to the latest version of the Epilog Software Suite (see above) before updating your machine's firmware.

INSTALL 1.0.1.0 FIRST
Harap diingat: Firmware release 1.0.2.2 can only be installed onto Fusion machines that have already been updated to at least 1.0.1.0. Be sure your machine has first been updated to Firmware release 1.0.1.0 (available below) or later.

• UI enhancements
• Added units selection, inches or mm
• Added Undo/Redo buttons on keypad (particularly useful for settings changes)
• FiberMark S2 model support
• Added MAC address to network tab

Firmware: 1.0.1.0 (09/24/2019)

Harap diingat: Be sure to update to the latest version of the Epilog Software Suite (see above) before updating your machine's firmware.